Table of Contents
Advertisement
•
Locking bezel is damaged or broken or
will not lock into place.
•
Not seated correctly within the support
rail.
Load Rating of Type 3 Tie Down Points
(Rope Hook): 250 kg (551 lb).
Fitting the Type 3 Tie Down Points
WARNING
Bezel must be fully engage into the
rail to secure the tie down point for
safe use. The word 'Not Locked' will
be visible in the incorrectly installed tie
downs.
E134099
Ranger (TKE) Vehicles Built From: 02-05-2016 Vehicles Built Up To: 04-09-2016, EB3B-19G219-AKC enGBR, First Printing
Load Carrying
1.
Engage the base of the tie down point
into the rail channel while holding the
cleat vertically.
2. Slide along the rail until the pin on the
base of the tie down engages in a
desired hole on the rail.
3. Push the tie down in and rotate a
quarter turn clockwise until the tie
down cleat is horizontal and the locking
bezel "snaps" into place.
Removing the Type 3 Tie Down Points
1.
Grasp the locking bezel between the
thumb and fingers using the finger
recess.
2. Pull the bezel away from the rail until
the base of the tie down point is fully
disengaged from the rail channel.
3. Turn the tie down point a quarter turn
anticlockwise until it snaps out of the
2
rail.
Load Rest
1
crosswinds and at high speeds.
182
WARNINGS
A loaded load rest alters the vehicle's
center of gravity and aerodynamics.
Take care when cornering, driving in
Do not exceed the permissible gross
weight. See Vehicle Identification
Plate (page 301).
Advertisement
Table of Contents
Troubleshooting
