Ford RANGER 2016 Owner's Manual page 165

Hide thumbs Also See for RANGER 2016:
Table of Contents

Advertisement

The selected gap appears in the
information display as shown by the bars
in the graphic. You can select from one of
four gap settings.
Adaptive cruise control gap settings
Set speed
km/h (mph)
100 (62)
100 (62)
100 (62)
100 (62)
Note: The system status and settings will remain unchanged each time you switch the
ignition on.
Overriding the System
WARNING
Whenever the driver is overriding the
system by pressing the accelerator
pedal, the system does not
automatically apply the brakes to maintain
separation from any vehicle ahead.
You can override the set speed and gap by
pressing the accelerator pedal.
When you override the system,
the green indicator light
E144529
illuminates and the set speed
text darkens.
The system resumes operation when you
release the accelerator pedal. The vehicle
speed decreases to the set speed, or a
lower speed if following a slower vehicle.
Automatic Cancellation
The system does not operate below
20 km/h (12 mph). An audible warning
sounds and the automatic braking releases
if the vehicle drops below this speed.
Ranger (TKE) Vehicles Built From: 02-05-2016 Vehicles Built Up To: 04-09-2016, EB3B-19G219-AKC enGBR, First Printing
Cruise Control
Graphic display, bars
indicated between
vehicles
1
2
3
4
Note: The gap setting is time dependent
and therefore the distance will
automatically adjust with your speed.
Time gap, seconds
0.8
1.2
1.6
2.1
Automatic cancellation can also occur if:
The tires lose traction.
The engine speed is too low.
You apply the parking brake.
Note: If the engine speed drops too low,
the information display indicates low engine
speed. Shift to a lower gear (manual
transmission only) to avoid automatic
cancellation.
Hilly Condition Usage
You should select a lower gear position
when the system is active in situations
such as prolonged downhill driving on
steep grades, for example in mountainous
areas. The system needs additional engine
braking in these situations to reduce the
load on the vehicle's regular brake system
to prevent them from overheating.
Note: An audible warning sounds and the
system shuts down if it applies brakes for
an extended period of time. This allows the
brakes to cool down. The system functions
normally again when the brakes have cooled
down.
162
Gap
m (yd)
28 (31)
39 (43)
50 (55)
61 (67)

Advertisement

Table of Contents
loading

Table of Contents