Table of Contents
Advertisement
ENGINE OIL DIPSTICK - 2.5L
DURATEC-HE (122KW/165PS)
- MI4
A
B
E92036
A
MIN
B
MAX
ENGINE OIL DIPSTICK - 2.2L
DURATORQ-TDCI (PUMA)
DIESEL/3.2L DURATORQ-TDCI
(PUMA) DIESEL
A
B
E71362
A
MIN
B
MAX
ENGINE OIL CHECK
1.
Make sure that your vehicle is on level
ground.
Ranger (TKE) Vehicles Built From: 02-05-2016 Vehicles Built Up To: 04-09-2016, EB3B-19G219-AKC enGBR, First Printing
Maintenance
2. Switch off the engine and wait 10
minutes for the oil to drain into the oil
pan.
3. Remove the dipstick and wipe it with
a clean, lint free cloth. Replace the
dipstick and remove it again to check
the oil level.
If the oil level is at the minimum mark, add
oil immediately. See Capacities and
Specifications (page 302).
Note: Check the oil level before starting the
engine.
Note: Make sure that the oil level is
between the minimum and the maximum
marks.
Note: Do not use oil additives or other
engine treatments. Under certain conditions,
they may damage the engine.
Note: The oil consumption of new engines
reaches its normal level after approximately
5,000 km (3,107 mi).
Adding Oil
Only add oil when the engine is cold.
If the engine is hot, wait 10 minutes
for the engine to cool down. Failure
to take care may result in personal injury.
Do not remove the filler cap when
the engine is running. Failure to take
care may result in personal injury.
1.
Remove the filler cap.
2. Add oil that meets Ford specifications.
See Capacities and Specifications
(page 302).
3. Replace the filler cap. Turn it until you
feel a strong resistance.
Note: Do not add oil further than the
maximum mark. Oil levels above the
maximum mark may cause engine damage.
259
WARNINGS
Advertisement
Table of Contents
Troubleshooting
