Table of Contents
Advertisement
4.10 USER PASSWORD
With the user password, only booting up the system is accepted, but changing the BIOS
setup is not allowed.
4.11 IDE HDD AUTO DETECTION
When users can not find the Hard Disk information, it is very helpful to use this option.
1.
Choose this item and press <Enter>.
2.
After couple seconds, the screen will appear the Hard Disk information and
following message:
"SELECT PRIMARY MASTER OPTION(N=SKIP): N"
3.
Enter Y or N to confirm the acceptance then enter.
4.
The process will repeat for Primary Slave, Secondary Master and Secondary
Slave Hard Disks.
4.12 SCSI HARD DISK INSTALLATION
In Standard CMOS Setup Utility, select hard disk type to be "Not Installed". In
Advanced CMOS Setup Utility, Disable "Adapter ROM Shadow DC00". On the SCSI
Controller card, set the jumpers which configure the SCSI card BIOS segment address
located at DC00 or DE00. Format the SCSI disk by the Formatter provided in the SCSI
BIOS.
4.13 SAVE & EXIT SETUP MENU
When you select this function, the following message will appear at the centre of the
screen to assist you to Save data to CMOS and Exit the Setup.
Save to CMOS and Exit (Y/N)?
Award BIOS Setup Guide
43
Advertisement
Table of Contents
