Cisco Aironet 340 Series Installation And Configuration Manual page 75

Chapter 7 Routine Procedures
Step 18 Insert the client adapter (with the Cisco logo facing up) into the PC card slot of the Windows CE device.
Refer to the
instructions on inserting the client adapter.
The Windows CE device should configure the client adapter, and the green LED on the adapter should
blink. If this does not happen, remove the client adapter, reset the Windows CE device, and reinsert the
client adapter.
The Cisco Wireless LAN Adapter Settings dialog box appears. (If the dialog box does not appear, select
Step 19
Start, Settings, Control Panel, Network, the Adapters tab, the Cisco Aironet wireless LAN adapter,
and Properties on HPC devices or Start, Settings, the Connections tab, Network, and the Cisco
Aironet wireless LAN adapter on PPC devices.)
Perform one of the following:
If your device is connected to a DHCP server, select Obtain an IP address via DHCP or Use
•
server-assigned IP address and click OK.
If your device is not connected to a DHCP server, select Specify an IP address or Use specific IP
•
address and follow the steps below:
a.
b.
c.
Double-click the Cisco ACU icon or select Start > Programs > Cisco > Aironet Client Utility to open
Step 20
ACU. The ACU screen appears (see
Figure 7-4
OL-1375-02
"Inserting a PC Card into a Windows CE Device" section on page 7-2
Enter the IP address, subnet mask, and default gateway address you want to assign to your
device. They can be obtained from your system administrator.
Select the Name Servers tab and enter the primary and secondary DNS and WINS you want to
assign to your device. They can be obtained from your system administrator.
Click OK.
ACU Screen
Cisco Aironet Wireless LAN Client Adapters Installation and Configuration Guide for Windows CE
Figure 7-4).
Upgrading the Client Adapter Software
for specific
7-9