Cisco Aironet 340 Series Installation And Configuration Manual page 58

Configuring Your Client Adapter
Table 5-1
Parameter
Transmit Power
Click OK at the bottom of the ACU screen to save any changes you have made.
Step 2
Cisco Aironet Wireless LAN Client Adapters Installation and Configuration Guide for Windows CE
5-8
Client Adapter Configuration Parameters (continued)
Description
Defines the power level at which your client adapter transmits. This
value must not be higher than that allowed by your country's regulatory
agency (FCC in the U.S., DOC in Canada, ETSI in Europe, MKK in
Japan, etc.).
Options: Dependent on the power table programmed into the client
Default: Max (the maximum level programmed into the client adapter
Power Levels
Max, 100 mW, 50 mW,
30 mW, 20 mW, 5 mW, or
1 mW
Max, 30 mW, or 1 mW
Max, 30 mW, 15 mW,
5 mW, or 1 mW
Note
Note
Note
Note
adapter; see the table below
and allowed by your country's regulatory agency)
Client Adapter Type
350 series PC and LM cards
340 series PC cards
340 series LM cards
Reducing the transmit power level conserves battery power but
decreases radio range.
If the client adapter is running, ACU queries the adapter and
displays the settings programmed into the adapter. If the client
adapter is not running, ACU displays power level options based
on the last known radio type.
When World Mode is enabled, the client adapter is limited to
the maximum transmit power level allowed by the country of
operation's regulatory agency.
If you are using an older version of a 340 or 350 series client
adapter, your power level options may be different than those
listed here.
Chapter 5 Advanced Configuration
OL-1375-02