Cisco Aironet 340 Series Installation And Configuration Manual page 116

Using Active Mode
Table E-2
Parameter
Destination MAC Address
Destination Is Another Cisco
Aironet Device
Number of Packets
Data Rate
Continuous Link Test
Packet Size
Delay Between Packets
Cisco Aironet Wireless LAN Client Adapters Installation and Configuration Guide for Windows CE
E-6
Site Survey Active Mode Parameters
Description
The MAC address of the access point (in infrastructure mode) or other
clients (in ad hoc mode) that will be used in the test.
Default: The MAC address of the access point (in infrastructure mode)
Note
Selecting this checkbox indicates that the device you named in the
Destination MAC Address field is a Cisco Aironet access point (in
infrastructure mode) or client (in ad hoc mode). In this case, packets sent
to the client from the Cisco Aironet device contain additional information,
such as lost to source, lost to target, and percent retries, and this
information is displayed in the Site Survey - Active screen.
If the device specified in the Destination MAC Address field is not a
Cisco Aironet device, do not select this checkbox. In this case, the test
sends out loopback packets, which originate from and return to the
client adapter.
Default: Selected
The number of packets that will be sent during the test.
Range: 1 to 999
Default: 100
The bit rate at which packets will be transmitted. Rate shifting will not
occur during the test because the echo test built into the radio firmware
does not support it
Value: 1, 2, 5.5, or 11 Mbps
Default: 11 Mbps
Selecting this checkbox causes the test to run until you click OK or
Stop. The test loops repeatedly for the number of packets specified in
the Number of Packets field.
Default: Deselected
The size of the packets that will be sent during the test. Select a size that
will be typical during normal system use.
Range: 30 to 1450
Default: 512
The delay (in milliseconds) between successive transmissions.
Range: 1 to 2048 ms
Default: 50 ms
to which your client adapter is associated
During the test, the client adapter will not roam to other access
points so that the size of a single cell can be determined.
Appendix E Performing a Site Survey
OL-1375-02