Enabling Leap; Entering The Leap Username And Password - Cisco Aironet 340 Series Installation And Configuration Manual

Using LEAP

Enabling LEAP

Follow the steps below to enable LEAP for your client adapter.
Double-click the Cisco ACU icon or select Start > Programs > Cisco > Aironet Client Utility. The
Step 1
ACU screen appears (see
Figure 4-8
Step 2 Select LEAP under Property.
Step 3 Select Enabled in the Value box.
Click OK to enable LEAP and exit the utility. When LEAP is enabled, the following parameters in the
Step 4
ACU screen are changed automatically:
•
•

Entering the LEAP Username and Password

Follow the steps below to enter the LEAP username and password.
WLM starts automatically whenever you start ACU with a client adapter inserted, change the LEAP
Step 1
parameter from Disabled to Enabled, and click OK. If LEAP is already enabled, WLM starts
automatically whenever you insert the client adapter, reboot or reset the Windows CE device, or load
new firmware.
Note
When WLM starts, the Wireless Login Module screen appears (see
Cisco Aironet Wireless LAN Client Adapters Installation and Configuration Guide for Windows CE
4-12
Figure
ACU Screen
WEP is set to Enabled.
Authentication Type is set to Open.
You can also start WLM by selecting Start > Programs > Cisco > Wireless Login Module.
You may want to do this if you inadvertently exited WLM after it started or if you roam to a
different part of the network where a different login is required.
4-8).
Chapter 4 Enabling Security Features
Figure 4-9).
OL-1375-02