Technical Data; Installation; Transportation And Handling - Ecotech Italia 60 Series User And Maintenance Manual

3.7

TECHNICAL DATA

BT 60
Engine Honda GCV 160
Ignition
Transmission Belt and
mechanical
Gears 1
Speed 1.6 km/h
Cutting 20 cm off the
width
right wheel
Cutting
height
Rut 580 mm
Wheels
13" pneumatic
Dry weight 38 kg
Noisiness
Table 3-2: Technical data
4

INSTALLATION

4.1

TRANSPORTATION AND HANDLING

When lifting/lowering the machine, always lay it down progressively.
•
• Always tilt the
inspection/maintenance/cleaning under the cutting surface, in order to prevent oil and fuel from leaking. This
operation should always be performed when the engine is off and there are no parts moving.
• When loading a vehicle with the machine, always use solid ramps and make sure that manoeuvres are made at
minimum speed, paying attention to keep the wheels of the machine inside the tracks.
4.1.1 Packaging
The machine is packed as shown in the picture below:
WARNING! THE FORKLIFT CONTACT POINT IS THE ONE SHOWN IN THE PICTURE!
4.2 STORAGE
If the machine is not used for a long period of time, it is advisable to:
Empty the fuel tank;
•
• Lubricate the cylinder with suitable products, which you may buy from your supplier;
Clean the air filter;
•
• Remove the remaining fuel from the carburettor tank;
Grease the parts of the machine which have lost their paint due to wear or bumps and the parts where the zinc coating
•
is worn out, in order to prevent rusting.
DCS 60 DCS 60 Traction
- -
- - 1
- - 1.6 km/h
Max 600 mm
30-45-60 mm
600 mm 580 mm
16" 13" pneumatic
33 kg 38 kg
98 dB
machine backwards
Figure 4-1: Package showing the lifting point/direction
MC 60
Honda GCV 190
Honda GXV 160
Pull start, with recoil
Belt and mechanical
500 mm
49 kg
96 dB
(lowering the handlebar
TRL 60 TRT 60
550 mm 500 mm
20÷80 mm 20÷100 mm
51 kg 50 kg
98 dB 96 dB
towards the ground)
TRT 60 Pro
Honda GXV 160
3
1.5 – 1,9 - 3
km/h
500 mm
20÷100 mm
50 Kg
96 dB
in case of