Operating Principle; Environmental Conditions; Noise Emission - Ecotech Italia 60 Series User And Maintenance Manual

OPERATING PRINCIPLE

3.1
3.1.1 Expected use
The 60 series you bought was designed and produced in order to work on flat ground, of maximum slope of 15°. The work
potential changes depending on the assembled cutting surface.
Type of cutting surface
BT
DCS
MC
TRL
TRT
3.2 SIZE
Model
BT 60
DCS 60
DCS 60 Traction
MC 60
TRL 60
TRT 60
TRT 60 Pro
Table 3-1: Size
3.3

ENVIRONMENTAL CONDITIONS

The machine does not require any particular environmental conditions. It can work on dry grass, but also on wet grass, paying
attention to adjust the cutting waste opening to the maximum width possible, in order to avoid jamming the cutting surface,
which may result in engine fatigue.
LIGHTING
3.4
The machine was designed and produced to work outside with natural light. In case of night time work, make sure good artificial
lighting is present, equal to at least 150 lux (UNI EN 12646-2:2008).
3.5 VIBRATIONS
Operating conditions:
Engine rotation speed during tests: 3000 rpm.
3.6

NOISE EMISSION

Pondered equivalent continuous acoustic pressure level A in workplaces is the following:
Any other phonometric measurements in workplaces should be performed in compliance with the regulations in force in the
country where the machine is used.
Expected use
Trimming and cutting grass/brambles/scrubs, even in the presence of debris.
Cutting grass/brambles/scrubs on untilled land and underwood, particularly suitable for finishings and cutting operations on
grounds with debris.
Cutting medium size grass and scrubs with good grinding of the cut material.
Cutting grass in a meadow or garden, particularly suitable for not excessively high grass, resulting in good finishings.
Cutting medium- and large-size grass/brambles/scrubs on untilled land and underwood, in extreme work conditions.
Size
Length (mm)
1600
1600
1600
1850
1800
1800
1800
In the presence of high grass, it is possible to facilitate the penetration of the
grass inside the cutting surface by removing the wall on the front of the cutting
surface (Figura 3-8 No.1) removing the three clamp screws. Without this wall
the machine may throw objects, therefore KEEP PEOPLE, ANIMALS OR THINGS
AT A MINIMUM DISTANCE OF 15 METRES.
Figure 3-8: Particular TRL cutting surface opening
Aeq
Width (mm)
580
630
580
580
580
580
580
60 series
X 1.6 m/s²
Y 2.2 m/s²
Z 4.1 m/s²
60 series
96 - 98 dB(A)
Height (mm)
970
970
970
970
1020
1020
1020