3.5
VIBRATIONS
Operational Conditions:
Motor RPM during tests 3000 rpm.
3.6
NOISE EMISSIONS
The weighted equivalent continuous sound pressure level A in the work station is:
Other phonometric measurements in the workplace must be performed pursuant to what is provided for in the standards in
force in the country of use.
3.7
TECHNICAL SPECIFICATIONS
BT 60
Motor
Honda GCV 160
Start up
Transmission
Belt and mechanical
Speed
1,6 Km/h
Cutting width
20 cm out of right wheel
Cutting height
Track
580 mm
Wheels
13" pneumatic
Dry weight:
38 Kg
Noise levels
Table 3‐2: Technical Specifications
4
INSTALLATION
4.1
TRANSPORT AND HANDLING
In case of hoisting/lowering always set the machine down progressively.
Always lay the machine down backwards (lowering the handle bars toward the ground) when
inspecting/maintaining/cleaning under the cutter plate, to avoid fuel or oil leaks. This operation is to always be
performed with the motor and the moving parts stopped.
When loading aboard a vehicle, always use solid ramps and pay attention to performing the loading operations at the
lowest speed, paying attention to keeping the wheels of the machines inside of the guides.
4.1.1
Packaging:
The machine packaging is as shown in the following photo:
ATTENTION! THE LIFTING POINT FOR THE FORK LIFT FORKS IS INDICATED IN THE FIGURE!
DCS BT 60 Traction‐Swing Top
AEQ
DCS BT 60 Traction‐Swing Top
DCS 60
‐ ‐
‐ ‐
Max 600 mm
600 mm
16"
33 Kg
Figure 4‐1 Packaging with the arrow / direction for hoisting
X 1.6 m/s²
Y 2.2 m/s²
Z 4.1 m/s²
93 dB (A)
DCS 60 Traction
Honda GCV 190
Honda GXV 160
Recoil pull starter
Belt and mechanical
1,6 Km/h
Max 600 mm
30‐45‐60 mm
580 mm
13" pneumatic
38 Kg
92 dB
DCS 60 Swing Top
Belt and mechanical with
variable speed control
Da 1 a 2,3 Km/h
Max 600 mm
min. 520
max 780 mm
13" steel toothed
42 Kg