Maintenance - Ecotech Italia 60 Series User And Maintenance Manual

Table of Contents

Advertisement

Available languages

Available languages

OPERATING MODES
6.2
6.2.1
WORK ON FLAT SURFACES
After performing the preliminary checks under point 4.3 and starting the engine, operate the blade rotation lever (Figure 6-3 No.
2), select the gear you want to use during work (depending on the model), operate the progress lever (Figure 6-3 No. 3), and
start working, in any case being as prudent as possible.
NORMAL STOP
6.3
Having finished working, in order to stop the engine, turn the fuel knob to the STOP position (or if there is not one on
the engine, use the stop switch, again after lowering the engine rounds per minute to a minimum), then close the fuel
tap, if present.
6.4
EMERGENCY STOP
In case of malfunctioning during work, simply release the handlebar, the machine will stop progressing and the blades will stop
rotating.
To stop the engine, see the previous point.
7

MAINTENANCE

STATE OF MAINTENANCE
7.1
BEFORE performing any maintenance operation on the machine, switch off the engine and wait until the
blades stop rotating completely.
If maintenance operations are not carried out, the machine can be damaged and the user and/or any other people in the area
may be injured. This damage and these injuries are not covered by the warranty.
Daily maintenance operations should be performed by the user.
Maintenance operations after the first 20, 100 and 300 hours of operation should be performed at the supplier's
premises.
Ask the supplier to check the machine, if you experience any problems.
CLEANING
7.2
WARNING!!! STRICTLY AVOID USING HYDROJET PUMPS.
Figure 6-3: 60 Swing series handlebar

Hide quick links:

Advertisement

Table of Contents
loading

This manual is also suitable for:

Bt 60Dcs 60Dcs 60 tractionMc 60Trl 60Trt 60 ... Show all

Table of Contents