Connect The Machine - Magicfx FLAMEBLAZER User And Installation Manual

Hide thumbs Also See for FLAMEBLAZER:

Table of Contents

Take the necessary safety precautions, including:

Creating a safety zone with a distance of 3 m around the effect of the

FLAMEBLAZER and a suitable clearance height depending on nozzle size.

This is calculated by taking the maximum height of the installed nozzle

and adding 50 % safety factor as follows:

•

S nozzle = 9 m (6 m + 50 %);

•

M nozzle = 12 m (8 m + 50 %);

•

L nozzle = 15 m (10 m + 50 %).

Making sure that the direct output will be free from persons, animals and

property.

Making sure there are no objects near the machine and within the output

distance that can be damaged or catch fire by the emitted heat, flame

and fuel from the FLAMEBLAZER.

3.5

CONNECT THE MACHINE

1. Install the ARM CONTROLLER in compliance with the instructions from the ARM

CONTROLLER User and Installation Manual (PART01882).

2. Connect the PowerCon TRUE1 power cable to the power input of the

FLAMEBLAZER. Connect the other end to a 100-250 Vac (50-60 Hz) power

source.

3. Connect the correct cables between the ARM CONTROLLER, the FLAMEBLAZER,

the control equipment, and other ARM SYSTEM components and machines (if

applicable). Check the following variants for connection details.

MAGICFX FLAMEBLAZER

— User and Installation Manual

Table of Contents