Magicfx FLAMEBLAZER User And Installation Manual page 17

Make sure there are no objects near the machine and within the
WARNING
output distance that can be damaged or catch fire by the
emitted flame and fuel from the FLAMEBLAZER.
Make sure there are no substances or gasses present that can be
WARNING
ignited by the emitted flame and fuel from the FLAMEBLAZER.
Using a damaged or an improper installed machine can lead to
WARNING
death, serious injury or property damage. Always inspect the
machine thoroughly before operation.
Stop operating the machine immediately if emitted fuel catches
WARNING
fire on the unit or in the burn chamber. Extinguish any burning
fuels with Carbon Dioxide, sand or foam. Consult the safety data
sheet from the supplier for detailed safety instructions.
Always create a suitable safety zone around the effect of the
WARNING
FLAMEBLAZER. Furthermore, keep a clearance of an additional 50
% from the maximum height range of the installed e.g. S nozzle
has a height range of up to 6 m so needs 9 m clearance above
(6 m + 50 %). The advised safety zones depend on the size of the
nozzle as each produces a different size flame as follows:
Note that the zone direction shifts accordingly when the machine
is installed in a tilted position.
Note that the zone shifts and increases with wind. As an
approximate guide the distance measurement from the wind
speed (in m/s) should be added to the standard safety zone e.g.
wind speed of 5 m/s can add 5 m to the typical 3 m resulting in
an 8 m safety zone in the direction of wind.
• S nozzle = 2 m;
• M nozzle = 2.5 m;
• L nozzle = 3 m.
MAGICFX FLAMEBLAZER
— User and Installation Manual
®
17