Set User Defined Recording - FCS Soundsens i User Manual

Set User Defined Recording

Set User Defined Recording
Press any key to wake up display.
Time and Date should be displayed.
Press MODIFY three times
Display should read...
Time and Date
Recording Setup?
(OK) To Start
Display will show
Recording Start
Delay 01Min
Press OK to accept
Display will show
Length of each
Recording
Press OK to accept
Display will show
Recording Interval
Delay 01Min
Press OK to accept
Display will show
Number of
Recording :3
Press OK to accept
Display will show
Setting up
Recording
Followed by
8 Loggers 0000
Programmed 0000
SoundSens User Guide
Leak Localisation and correlation
Displayed
Press OK
Please Note:
When the loggers have been programmed the display
will switch off after 20 seconds to save battery power.
Wake up the display by pressing any key. It should
show the current recording session countdown time, or
the time and date if recordings have finished.
SoundSens User Guide
©Radcom (Technologies) Ltd
After the loggers have been
programmed the display will change to
a countdown timer showing the time
until the recording starts and the
number of recordings left (number in
brackets).
14 :31 04/02/07
Rec 00:00:00 (3)
If a recording is taking place
then the display will show the
following message.
14 :31 04/02/07
Recording in progress
The number of loggers programmed
depends on the number of loggers in the
case.
Each 0 shown on the right represents a
logger in the case.
Page 29 of 63