Table of Contents
Advertisement
Downloading Data To The Carry Case
Data can be held in the carry case and downloaded to a PC or Laptop at a later stage. To
download data after a recording:
1. Place the pods back into the case (in any order or position) and lower the front
panel.
2. Press MODIFY to cycle through the menu options until you see "Download Data"
3. Press OK to start the download
A message will be displayed during data transfer. After downloading data from the pods a
confirmation message is shown. This is the same format used after setting up a recording
and shows which loggers have transferred data.
Viewing Stored Data Details
This option shows a summary of data sets stored in the SoundSens i. A 'set' is the
collection of data transferred during a download. The summary shows the set number,
number of pods used and the start time of the first recording, e.g.
1. Select the Stored Data? option with MODIFY
2. Press OK to view the summary for the first set
3. Press OK to view the next set
When all sets have been displayed there is an option to delete the last set. Note the
delete operation cannot be undone.
1. Select the Stored Data? option with MODIFY
2. Press OK until all the sets have been seen and the message "Remove last set" is
shown
To delete the data use the MODIFY key to select YES then press OK
Memory Capacity
There is enough memory in the case to hold 4 downloads from 8 SoundSens i correlator
pods which are full of data. When the case and all the pods are full of data you will not be
able to record any more and you will see "Memory Full" on the display. Either download
the data to a PC or erase some data from the View Data menu.
One pod will hold approximately 120 seconds of data.
SoundSens User Guide
Leak Localisation and correlation
DOWNLOAD
----
COMPLETE
-OO-
SET: 02 PODS: 06
09:50 20/02/07
SoundSens User Guide
©Radcom (Technologies) Ltd
Page 25 of 63
Advertisement
Table of Contents
