Setup Without Pc; Basic Carry Case Operation - FCS Soundsens i User Manual

Setup Without PC

Basic Carry Case Operation

Please note
When the carry case is not being used it will switch to a low power standby mode for
battery conservation, so the carry case display will turn off after 20 seconds if no buttons
are pressed. If you are in the middle of making any changes or setting up a recording
session you will have to start again.
The carry case display can be reactivated by pressing OK, CANCEL, or MODIFY. The
first thing you see on the display will always be the time and date – You must check that
this is correct before setting up a recording. However the chances of the time being
wrong are very small because every time the SoundSens software communicates with the
carry case it will synchronise the time.
In addition to the time/date this screen can also show
• BATTERY LOW (if the battery needs charging)
• BATTERY CHARGING (when the charger is plugged in)
• Recording countdown (time until next recordings starts) if neither of the above apply
and a recording has been set up.
The format for the recording countdown is: HH:MM:SS (N)
HH – Hours
MM – Minutes
SS – Seconds
N – Number of recordings remaining
Pressing the MODIFY key cycles through the main options.
To select an option press OK.
Pressing CANCEL returns to the time/date screen.
Main options (Press Modify to cycle through):
• Time/Date
• Set recording 1? (30min delay) – daytime quick recording setup
• Set recording 2? (2am start) – overnight quick recording setup
• Recording setup? – Custom recording setup
• Download data?
• Stored data
• Set time/date
SoundSens User Guide
Leak Localisation and correlation
SoundSens User Guide
©Radcom (Technologies) Ltd Page 19 of 63