Set Recording 1 (30 Minute Delay) - FCS Soundsens i User Manual

Set Recording 1 (30 Minute Delay)

Set Recording 1 (30 Min Delay)
Press any key to wake up display.
Time and Date should be displayed.
Press MODIFY once
Display should read...
Time and Date
Set Recording 1?
(30 Min Delay)
The number of loggers programmed
depends on the number of loggers in the
case.
Each 0 shown on the right represents a
logger in the case.
The display will then change to a
countdown timer showing the time until the
recording starts and the number of
recordings left (number in brackets).
14 :31 04/02/07
Rec 00:00:00 (3)
Please Note:
When the loggers have been programmed the display
will switch off after 20 seconds to save battery power.
Wake up the display by pressing any key. It should
show the current recording session countdown time, or
the time and date if recordings have finished.
SoundSens User Guide
Leak Localisation and correlation
Displayed
SoundSens User Guide
©Radcom (Technologies) Ltd
Press OK
A recording session will be set up
with the following settings...
3 Recordings
20sec Duration
5 min Intervals
This is not shown on the display.
The display will
show
Setting up
recordings
Followed by
8 Loggers
Programmed 0000
If a recording is taking place
then the display will show the
following message.
14 :31 04/02/07
Recording in progress
0000
Page 27 of 63