Table of Contents
Advertisement
Trigger Type
Trigger time
Cycle Time
Time
Frequency
Play Audio
Prompt Tone
Make Call
Dial out extension
Hang up
Recording
Backup/Restore
Backup/Restore page is used to back up data or import backup files to restore data. Users can start the Backup by clicking on
"Backup".
Maintenance Page Definitions
connected when the electrical action is on the switch, and the normally closed will disconnected. The default
is normally open.
Set the type of the trigger mode, and when the selection is level triggered, only high level (1) or low level (0)
will trigger the notification. When the edge trigger is selected, the notification is triggered only when the level
changes (high level to low level, or low level to high level). The default is level trigger.
The alarm can be configured to be triggered all days of the week, in this case "All days" option needs to be
checked. Or to some specific schedule, in this case "Period of Time" option needs to be checked for users to
be able to configure Time and Frequency options below.
Set the activation time, up to 3 times. When the activation time is not set, the default time is full day.
Set the activation frequency from Monday to Sunday, which can be selected from the whole week. The default
value is not selected.
Play a sound when the switch is triggered during the scheduled time.
When the "voice prompt" is selected, you can upload the customized audio by clicking on "Upload" and
choose the file.
Dial the number when the sensor is activated.
Enter the number you need to dial and click the "add" button to set two numbers at the same time.
Hang up calls when the sensor is triggered, such as SIP call, multicast, etc. When checked at the same time as
Make Call, if there is currently a call, the first trigger will hang up the call, and the second trigger will dial.
Start recording when the sensor is activated.
Table 31: Sensor Settings
Figure 44: Backup/Restore
Advertisement
Table of Contents
