Table of Contents
Advertisement
GE MEDICAL SYSTEMS
REV 21
3–8–1 GAS SPRING REPLACEMENT (continued)
33. Ensure that the nylon washer is in place (see Illustration 3–12) on the monitor arm.
34. Position the arm wire harness over the pin hole (see Illustration 3–12).
35. Gently place the monitor on the monitor arm, aligning the groove of the rotation slider with the pin–hole of the
monitor arm. Take care to route the wire harness through the groove. (see Illustration 3–11 and 3–12)
36. Connect the connector. (see Illustration 3–11 and 3–12)
37. Fix the neck pins and insert the rubber plugs. (see Illustration 3–12)
38. Ensure that the monitor arm does not pinch the wire harness. (see Illustration 3–12)
39. Fix the bottom (sub) cover. (see Illustration 3–10)
40. Install the bellows removed in step 10 to both the monitor arm and the main unit. Additional Adhesive may be used
to secure Bellows. (see Illustration 3–15)
3–8–2 Keyboard (Track Ball, TGC Assy) Replacement
1.
Remove the two rubber plugs and screws from the front cover. (see Illustration 3–20)
2.
Remove the front cover by unscrewing its three screws and the bottom cover of keyboard by unscrewing its
seven screws. (see Illustration 3–20)
3.
Disconnect the three cables from keyboard unit to the main unit. (see Illustration 3–21)
4.
Unscrew the eight keyboard screws. (see Illustration 3–21)
5.
Remove the keyboard (pc boards and touch panel as one assembly).
6.
If required, remove the track ball assembly by disconnecting the connector and then unscrewing the four nuts.
7.
If required, remove the TGC assembly by disconnecting the connector and then unscrewing the four screws.
8.
Install the new keyboard and fasten its eight screws.
9.
If removed, install the new track ball assembly, connect its connector, and screw it with its four nuts.
10. If removed, install the new TGC assembly, connect its connector, and screw it with its four screws.
11. Install the bottom cover with its seven screws.
12. Install the front cover with its five screws and two rubber plugs.
RTfino/RT3200 Advantage–II/RT–x200 SERVICE MANUAL
3–28
INSTALLATION AND REPLACEMENT
P9030GX
Advertisement
Table of Contents
