Troubleshooting - Silvercrest SLE 200 B2 Operating Instructions Manual

Troubleshooting

The following table will help you to identify and rectify minor malfunctions.
If the solutions below do not resolve the problem, please contact Customer
Service (see section Service).
Fault Possible cause
The plug w is not plugged in.
The mains power socket is not
The appliance
supplying power.
will not switch
on.
Safety stop due to missing or
incorrectly inserted water tank 4
The water tank 4 is full.
The automatic defrosting function
The appliance
is activated.
stops occasion-
ally (the fan
The humidity of the room has
switches off).
reached the desired level.
The air inlet (air inlet grille 2)
The appliance
or air outlet 8 openings are
is producing
contaminated or blocked.
no or too little
The room's windows and doors
condensate.
are open.
The air ejected
Heat exchange process
is warm.
The error code
Temperature sensor error/humidity
E 1 flashes on
sensor error
the display p
■ 20 │ GB │ IE
Remedy
Insert the plug w into the mains
power socket.
Check the house mains fuse.
Insert the water tank 4 correctly.
Empty the water tank 4 and reinsert it.
This is a normal feature of the
appliance.
This is a normal feature of the
appliance.
Ensure that the air inlet (air inlet
grille 2) and air outlet 8 openings
are clean and free of obstructions.
Close the windows and doors.
This is a normal feature of the
appliance.
Contact the Customer Service
department (see section Service).
SLE 200 B2