Table of Contents
Advertisement
7 Maintenance
4. Install the measuring device.
5. Take the combustion measurements to determine losses through flue gases and smoke.
6. Refit the plug on the flue gas measurement point.
7.3.4
Chimney mode
Tab.41
Type of access
Direct access: from the main home screen
Access: from any screen
Tab.42
Parameter name
ChimneyModeStatus
System Flow Temp
Power output
CH Set Max System
28
CFU
Access path
Not available
→ Press the
→ Select:
Parameter Description
Status of the Chimney mode
0 =Off
2 =Medium power
AM016
Flow temperature of appliance.
This value is given for information only.
AM051
Relative power output of the appliance
This value is given for information only.
AP063
Maximum flow temperature setpoint for burning at central heating
Can be set from 20 °C to 90 °C
The chimney sweep can access the Test mode menu.
1. Go to the menu: Test mode.
key
Test mode
2. Select one of the following parameters:
3. Go back to the main screen by pressing the back key
.
7740570 - v04 - 03112022
Advertisement
Table of Contents
