b. Apply low temperature resistant grease to
the specified lubrication point.
c. Apply corrosion resistant grease to the
specified lubrication point.
▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲
Greasing the clamp bracket bolt
(through tube)
1. Remove the hydraulic steering cylinder or
steering cable from the through tube.
2. Clean inside of the through tube and the
hydraulic steering cylinder rod or steering
cable.
3. Apply a sufficient amount of grease to the
inside of the through tube and to the hy-
draulic steering cylinder rod or steering ca-
ble.
4. Assemble the hydraulic steering cylinder
or steering cable to the through tube.
Checking the PTT fluid level
Never get under the outboard motor while it
is tilted.
1. Check:
• PTT fluid level
▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼
a. Fully tilt the outboard motor up, and then
support it using the tilt support knob "1".
10-20
General periodic maintenance
1