Clear Credit Token; Initiate Dispenser Test Token (Meter Non-Specific Token); Commissioning Token (Non Meter-Specific, Proprietary Token); Commissioning Token (Meter-Specific, Proprietary Token) - Landis+Gyr Cashpower Gem Lite User Manual

Meter Operation

4.5.7

Clear Credit Token

On accepting a clear credit token, the meter clears any remaining credit to zero and opens the latching relay,
thus interrupting the electricity supply to the customer.
4.5.8

Initiate Dispenser Test Token (Meter Non-Specific Token)

There are a number of non meter-specific tokens that can be used to test various functions on the meter.
On accepting an initiate dispenser test token, the meter executes all the tests that are embedded in that
particular token. The following tests are supported:
Function
Open the latching relay
HMI test - turns on all the LED‟s, displays all
segments on the LCD, and activates the buzzer
Display the total units counter
Display the key revision number and key type
Display the tariff index
Display the power limit level
Display the tamper state
Display the instantaneous power
Display the software version number
Test all the above functions (tests run
sequentially)
In a test sequence (test all), each test has a duration of 2.5 seconds, and is performed in the above order. For a
single test per token, the test duration is 5 seconds.
On completion of the test sequence, the meter returns to its normal mode of operation.
4.5.9

Commissioning Token (Non Meter-Specific, Proprietary Token)


It is typically used to assist meter installation personnel by ensuring that the load remains disconnected and the
tamper detect sensing switch function disabled (meter decommissioned).
Once the installation is complete and the number entered:

The latching relay closes

The tamper detect sensing switch function is enabled.

4.5.10 Commissioning Token (Meter-Specific, Proprietary Token)

This is a meter-specific token but in all other aspects its operation is the same as described in the paragraph
above.
Note: An already commissioned meter rejects a commissioning token.

4.5.11 Decommissioning Token (Meter-Specific, Proprietary Token)

On accepting a decommissioning token, the meter opens the latching relay (load disconnected) and disables
the tamper detect sensing switch function.
Note: An already decommissioned meter rejects a commissioning token.
Cashpower Gem Lite – User Guide
Review
The set credit levels token is not defined in the STS specification. It is a
Cashpower specific feature, and it uses one of the proprietary dispenser
specific management token subclasses.
This is a proprietary STS token i.e. it can only be used on a Landis+Gyr
STS meter: 1268 2136 5508 1001 3746. This is a non meter specific
number.
Token Number
0000 0000 0001 5099 7584
0000 0000 0001 6777 4880
0000 0000 0002 0132 8896
1844 6744 0738 4377 2416
3689 3488 1475 5332 2496
0000 0000 0012 0797 4400
0000 0000 0022 8172 8512
0000 0000 0044 2920 8064
0000 0000 0087 2419 5840
5649 3153 7254 5031 3471
15/27
© Landis+Gyr (Pty) Ltd