Table of Contents
Advertisement
SKYRC T400Q Instruction Manual
Lithium Battery Program (LiPo/LiFe/Lilon/LiHV)
1, A memory profile is available for setting and storing pertinent information for up to 40 different
program sets; each port can store 10 programs. Once a battery program is stored into memory,
it will be retained until changed again manually. Recalling a program memory number makes the
charger instantlyready to go!
2, If you do not wish to use the battery program memories, this charger can be manually set before
each use.
The following flowchart shows how the program is set manually:
PORT: A
SKYRC T400Q
10.
Port Select
Short-press the PORT button to switch between A, B, C and D ports, you will
see the port info with the arrow as the chart shown.
The default port is A. Please ensure the port selected is the same as the one
that your battery connected. Also the main and balance port are connected to
the same port.
Battery Type Select
Press INC and DEC to go through all the battery types and press ENTER/Start
to enter LiPo BATT Program.
Mode Select
Press INC and DEC to go through all the modes and press ENTER/Start to enter
LiPo Balance Charge Mode.
Battery Setting
Press ENTER/Start button, the present value will start to blink. Press INC and
DEC to change the value and press
ENTER/Start to confirm your setting. At the same time, the battery pack's cell
count will start to blink, press INC and DEC to change the value and press
ENTER/Start to confirm your setting.
Program Start
Press and hold ENTER/Start for 3 seconds to start the program.
The charger is detecting the battery cell.
R shows the number of cells detected by the charger and S is the number of
cells set by you on the previous screen. If
the two numbers are not identical, press STOP to go back to the previous screen
to recheck the number of cells of the
battery pack that you set before going ahead. If the two numbers are identical,
press ENTER/Start to start the charging process.
Charging Status Monitor
During charge process, real-time status will be shown as seen on the left.
Advertisement
Table of Contents
