Warning And Safety Notes; Standard Battery Parameters - Skyrc T400Q Instruction Manual

Ac/dc quattro balance charger/discharger
Hide thumbs Also See for T400Q:
Table of Contents

Advertisement

SKYRC T400Q Instruction Manual

Warning and Safety Notes

These warnings and safety notes are particularly important. Please follow the
instructions for maximum safety; otherwise the charger and the battery can be
damaged or at worst it can cause a fire.
Never leave the charger unattended when it is connected to its power supply. If any malfunction
!
is found, TERMINATE THE PROCESS AT ONCE and refer to the operation manual.
Keep the charger well away from dust, damp, rain, heat, direct sunshine and vibration. Never
!
drop it.
The allowable AC input voltage is 100~240V AC and DC input 11-18V.
!
This charger and the battery should be put on a heat-resistant, noninflammable and
!
nonconductive surface. Never place them on a car seat, carpet or similar. Keep all the
inflammable volatile materials away from operating area.
Make sure you know the specifications of the battery to be charged or discharged to ensure
!
it meets the requirements of this charger. If the program is set up incorrectly, the battery and
charger may be damaged .It can cause fire or explosion due to overcharging.

Standard Battery Parameters

Nominal
Voltage
Max Charge
Voltage
Storage
Voltage
Allowable
Fast Charge
Min. Discharge
Voltage
Be very careful to choose the correct voltage for different types of battery otherwise you may
cause damage to the batteries. Incorrect settings could cause the cells tofire or explode.
Never attempt to charge or discharge the following types of batteries.
!
A battery pack which consists of different types of cells (including different manufacturers)
A battery that is already fully charged or just slightly discharged.
Non-rechargeable batteries (Explosion hazard).
Batteries that require a different charge technique from NiCd, NiMh, LiPo or Gel cell (Pb, Lead
acid).
A faulty or damaged battery.
A battery fitted with an integral charge circuit or a protection circuit.
SKYRC T400Q
04.
LiPo
Lilon
3.7V/cell
3.6V/cell
4.2V/cell
4.1V/cell
3.8V/cell
3.7V/cell
≦1C
≦1C
3.0-3.3
2.9-3.2
V/cell
V/cell
LiFe
LiHV
3.3V/cell
3.7V/cell
3.6V/cell
4.35V/cell
3.3V/cell
3.90V/cell
≦4C
≦1C
2.6-2.9
3.1-3.4
V/cell
V/cell
NiMH
NiCd
1.2V/cell
1.2V/cell
1.5V/cell
1.5V/cell
n/a
n/a
1C-2C
1C-2C
0.1-1.1
0.1-1.1
V/cell
V/cell
Pb
2.0V/cell
2.4V/cell
n/a
≦0.4C
1.8V~2.0
V/cell

Advertisement

Table of Contents
loading

Table of Contents