Battery Memory Set And Call Out - Skyrc T400Q Instruction Manual

Battery Memory Set and Call Out

The charger can store up to 10 different charge/discharge profiles on each port for your
convenience, and the stored profiles can be recalled quickly without having to go through the setup
process. When you want to alter the parameter value in the program, press ENTER/Start to make
it blink then change the value with INC or DEC. The value will be stored by pressing ENTER/Start
once.
Note: All following screen are taking 2S(7.4V) LiPo battery for example.
1, Battery Memory Set
Enter the battery memory program.
(10 different charge/discharge profiles can be stored on each port).
Set the battery type(LiPo/LiHV/LiFe/LiIon/NiMH/NiCd/Pb).
Set the voltage and number of cells(1-6S).
Set the charge rate (0.1-12.0A).
Set the discharge rate (0.1A-2.0A).
Set the discharge voltage(3.0-3.3V/Cell).
Set the terminal voltage(4.18-4.25V).
Press ENTER/Start to save program.
Indicate the charge and discharge program of the saved profile. Press the
ENTER/Start for 3 seconds to call out the memory.
SKYRC T400Q Instruction Manual
.17 SKYRC T400Q