Table of Contents
Advertisement
Lithium Battery Program
(1)
A memory profile is available for setting and storing pertinent information for 10
different program sets. Once a battery program is stored into memory, it will be
retained until changed again manually. Recalling a program memory number
makes the charger instantly ready to go!
(2)
If you do not wish to use the battery program memories, this charger can be
manually set before each use.
The following flowchart shows how the program is set manually:
BATT/PROGRAM
LiPo BATT
START/ENTER
LiPo BALANCE
2.0A 11.1V (3S)
START/ENTER
LiPo BALANCE
2.0A 11.1V (3S)
START/ENTER
LiPo BALANCE
2.0A 11.1V (3S)
START/ENTER
LiPo BALANCE
2.0A 11.1V (3S)
START/ENTER
> 3 Seconds
e680
BATT/PROGRAM Select
Press INC and DEC to go through all the programs and
press START/ENTER to enter LiPo BATT Program.
Mode Select
Press INC and DEC to go through all the modes and press
START/ENTER to enter LiPo Balance Charge Mode.
Battery Setting
Press START/ENTER, the present value will start to blink.
Press INC and DEC to change the value and press
START/ENTER to confirm your setting.
At the same time, the battery pack's cell count will start to
blink, press INC and DEC to change the value and press
START/ ENTER to confirm your setting.
Program Start
Press and hold START/ENTER for 3 seconds to start the
program.
(LiPo/LiFe/Lilon/LiHV)
13 ·
Advertisement
Table of Contents
