Lithium Battery Program (Lipo/Life/Lilon/Lihv) - Skyrc T100 Instruction Manual

LITHIUM BATTERY PROGRAM (LIPO/LIFE/LILON/LIHV)

2. Getting started
It is highly recommended to have the flowchart handy while learning to operate this charger,
There are two main ways to setup the charger:
(1)Memory profile are available for setting and storing charge parameters for up to 10
different batteries. Once a battery's information is stored into memory, it will be retained until
changed again manually. Recalling a battery's memory number makes the charger instantly
ready to go!
(2)The other method is by manually setting up the charge process each time. The T100 is
capable of the following processes:
The following steps describe how to manual setup the T100
B A T T / P R O G R A M
L i P o B A T T
START/ENTER
L i P o B A L A N C E
2 . 0 A 1 1 . 1 V ( 3 S )
START/ENTER
L i P o B A L A N C E
2 . 0 A 1 1 . 1 V ( 3 S )
START/ENTER
L i P o B A L A N C E
2 . 0 A 1 1 . 1 V ( 3 S )
START/ENTER
L i P o B A L A N C E
2 . 0 A 1 1 . 1 V ( 3 S )
START/ENTER
> 3 Seconds
B A T T E R Y C H E C K
. . . . . . . . . . .
R : 3 S E R S : 3 S E R
C A N C E L ( S T O P )
T100
3. BATT/PROGRAM Select
Press INC and DEC to go through all the programs and
press START/ENTER to enter LiPo BATT Program.
4. Mode Select
Press INC and DEC to go through all the modes and press
START/ENTER to enter LiPo Balance Charge Mode.
5. Battery Setting
Press START/ENTER, the current value will start to blink,
press INC and DEC to change the value and press
START/ENTER to confirm your setting.
At the same time, the battery cells number will start to blink,
press INC and
START/ENTER to confirm your setting.
6. Program Start
Press and hold START/ENTER for 3 seconds to start the
program.
The charger is detecting the battery cell.
R shows the number of cells detected by the charger and S
is the number of cells set by you at the previous screen. If
both numbers are not identical, press STOP to go back to
previous screen to recheck the number of cells of the battery
pack before going ahead.
DEC to change the value and press
11 ·