Explanation Of Buttons - Skyrc T400Q Instruction Manual

SKYRC T400Q Instruction Manual

Explanation of Buttons

BATT PROG / STOP Button
It is used to stop the progress or go back to previous step/screen.
DEC Button
It is used to go through the menus and decrease the parameter value.
INC Button
It is used to go through the menus and increase the parameter value.
ENTER/Start Button
It is used to enter parameter or store parameter on screen.
PORT Button
It is used to switch between port A,B,C and D.
When you want to alter the parameter value in the program, press the ENTER/Start button to make
it blink then change the value by pressing DEC and INC button. The value will be stored by re-
pressing the ENTER/Start button. If there is another parameter can be altered in the same screen,
when you confirm the first parameter value, the next parameter value will start to blink which
means it is ready to alert.
When you want to start the progress, press and hold the ENTER/Start button for 3 seconds. When
you want to stop the progress or go back to previous step/screen, press the BATT PROG/STOP
button once. When you power on the charger, it will enter LiPo Battery balance program directly.
You could change the mode (balance mode, normal charge mode, fast charge mode, store mode
or discharge mode), enter the desired charging/discharging mode, set the referred parameter and
start the progress.
If you have no request for LiPo Battery program, please press the BATT PROG/STOP button to
enter BATT PROGRAM screen.
.07 SKYRC T400Q