Skyrc T400Q Instruction Manual page 15

[ END: FINISH ]
16.8V 2600mAh
[ TIME: 00: 45: 32 ]
16.8V 2600mAh
NiMH/NiCd Discharge Mode
[ END: CUTOFF - VOL ]
16.79V 00261mAh
NiMH/NiCd Re-Peak Mode
Applicable to NiMH and NiCD batteries only, in re-peak mode the charger can peak charge the
battery once, twice, or three times in a row automatically. This process is good for confirming that
the battery is fully charged and for verifying how well the
battery can accept a fast charge. A five-minute cool-down delay occurs after each repeak charge.
Once charging has commenced, the charger will display the following real-time
information: battery type, charging
current, battery voltage, elapsed time and charged capacity.
Once the battery is fully charged, the screen will read "END: FINISH" and the
charger will emit a ringing sound. Youcan press the STOP button at any time
during the charging process to stop charging.
After selecting the correct battery type, use the INC or DEC button to select the
DISCHARGE mode. Press the ENTER/Start
button and the amp rate value will begin flashing. Use the INC or DEC buttons
to adjust the value to the desired discharge rate. Press the ENTER/Start button
again and the voltage cut-off will begin to flash. Use the INC or DEC button
to adjust the value to the desired rate.
Follow the instructions provided on your battery when setting the voltage cut-
off. The T400Q will stop discharging when the battery has reached the preset
voltage cut-off.
Press and hold the ENTER/Start button for 3 seconds to start discharging. Once
discharging has commenced, the charger will display the following real-time
information: battery type, discharging current, battery voltage, working mode,
elapsed time and discharged capacity.
When discharging is complete, the screen will read "END: CUTOFF-VOL" and
the charger will emit a ringing sound.
The charger will display the elapsed time, end voltage and the discharged
capacity in mAh.
You can press the STOP button at any time during the discharging process to
stop the discharge process.
After selecting the correct battery type, use the INC or DEC button to select the
"RE-PEAK" mode. Press the ENTER/Start button and the Re-peak cycle number
1 begins to flash on the screen. Use the INC or DEC button to scroll through
the cycle count and set a number between 1 and 3. Press and hold the START
button for 3 seconds to start the re-peak process.
SKYRC T400Q Instruction Manual
.13 SKYRC T400Q