Table of Contents
Advertisement
Lithium Battery Program
The following flowcharts show the entire programming menu. It is highly recommended to
keep these flowcharts handy while you learn how to operate this charger.
There are two main ways to program the charger.
(1)
A memory profile is available for setting and storing pertinent information for up to
40 different program sets; each channel can store 10 sets. Once a battery program
is stored into memory, it will be retained until changed again manually. Recalling a
program memory number makes the charger instantly ready to go!
(2)
If you do not wish to use the battery program memories, this charger can be
manually set before each use.
The following flowchart shows how the program is set manually:
BATT/PROGRAM
LiPo BATT
START/ENTER
LiPo BALANCE CHG
2.0A 11.1V (3S)
START/ENTER
LiPo BALANCE CHG
2.0A 11.1V (3S)
START/ENTER
LiPo BALANCE CHG
2.0A 11.1V (3S)
START/ENTER
LiPo BALANCE CHG
2.0A 11.1V (3S)
START/ENTER
> 3 Seconds
D400
BATT/PROGRAM Select
Press INC and DEC to go through all the programs and press
START/ENTER to enter LiPo BATT Program.
Mode Select
Press INC and DEC to go through all the modes and press
START/ENTER to enter LiPo Balance Charge Mode.
Battery Setting
Press START/ENTER, the present value will start to blink. Press
INC and DEC to change the value and press START/ENTER to
confirm your setting.
At the same time, the battery pack's cell count will start to blink,
press INC and DEC to change the value and press START/
ENTER to confirm your setting.
Program Start
Press and hold START/ENTER for 3 seconds to start the
program.
(LiPo/LiFe/Lilon/LiHV)
15 ·
Advertisement
Table of Contents
