Lithium Battery Program (Lipo/Life/Lilon/Lihv); Nimh/Nicd Battery Program - Skyrc IMAX B6 V2 Instruction Manual

Professional balance charger/discharger
Table of Contents

Advertisement

Lithium Battery Program
VARIOUS INFORMATION DURING THE PROCESS
Press INC or DEC during the charging or discharging process to
view further pertinent information on the LCD screen.
Real-time status: battery type, battery
50% 10.20V
cell count, charge current, battery pack
C 2.0A
00301mAh
total voltage,working mode, elapsed
time and charged capacity.
INC
Voltage of each cell in the battery pack
3.87
3.89
3.86 V
when the battery is connected with
balance lead.
50% 10.20V
C 2.0A
00301mAh
DEC
End Voltage
Final voltage when the program ends.
12.6V(3S)
DEC
IN Power Voltage
Input voltage.
12.56V
DEC
Internal temperature.
Ext. Temp
----
Temperature probe needs to be connected
Int. Temp
37°C
to show external temperature.
DEC
Temp Cut-Off
Cut-off temperature.
50C/122F
   
DEC
Safety timer ON and duration of time in
Safety Timer
minutes.
ON
120min
DEC
Capacity cut-off ON and value of the set
Capacity Cut-Off
capacity limit.
ON
5000mAh
· 16
(LiPo/LiFe/Lilon/LiHV)
B6 V2
NiMH/NiCd:
This program is only suitable for charging/discharging NiMH/NiCd
batteries. The B6 V2 offers the following NiMH/NiCd charge modes:
Charge, Discharge, Re-Peak and Cycle.
Selecting the Battery Type:
After powering on the B6 V2, press the INC or DEC button repeatedly
until you reach the appropriate program for the battery type you wish
to charge. For this example we have chosen the "NiMH BATT" or
"NiCd BATT" program. Now press the ENTER button to enter the
desired program.
BEFORE YOU BEGIN CHARGING YOUR BATTERY,
MAKE SURE YOU ARE CHARGING NIMH/NICD
BATTERIES. CHARGING LIPO BATTERY UNDER NIMH/
WARNING!
NICD BATTERY PROGRAM WILL CAUSE FIRE.
NiMH/NiCd Charge Mode:
BEFORE YOU BEGIN CHARGING YOUR BATTERY, MAKE SURE
YOU HAVE READ AND UNDERSTOOD ALL OF THE WARNINGS
AND SAFETY INFORMATION CONTAINED ON PAGES 05-07.
After selecting the correct battery type, if the screen does not read
"CHARGE", use the DEC or INC buttons to change it to the
"CHARGE" mode.
Press the ENTER button and the amp rate
NiMH CHARGE
value will begin blinking. Use the DEC or INC
CURRENT
2.0A
button to adjust the value to the desired rate.
Follow the instructions provided on your battery
when setting the charge current.
START/ENTER
Press and hold the ENTER button for 3
seconds to start charging.
Once charging has commenced, the charger
NiMH
2.0A
6.22V
will display the following real-time information:
CHG
00:02:22
battery type, charging current, battery voltage,
working mode, elapsed time and charged
capacity. Once the battery is fully charged, the
NiMH
2.0A
6.22V
screen will read "FULL" and the charger will
CHG
00106mAh
emit a ringing sound. You can press the STOP
button at any time during the charging process
to stop charging.
B6 V2

NiMH/NiCd Battery Program

17 ·

Advertisement

Table of Contents
loading

Table of Contents