How To Configure The Module Parameters - ICP DAS USA I-7530A User Manual

3.1

How to configure the module parameters

1. Set the Init/Normal switch to the Init position, which is located at the
back of the I-7530A module.
2. Connect the power source (the 10~30 DC volts) into the I-7530A
module.
3. The I-7530A module's ON LED will flash approximately once per
second. That means the I-7530A module is working in the configuration
mode.
4. Run the I-7530A's Utility software after connect the PC COM port and
the I-7530A COM port by a RS-232 cable.
5. Click the "Connect" icon on the I-7530A Utility tool bar. The setting
frame will be popped up. Select which PC COM port will be used to
connect to the I-7530A COM port, as shown in the following figure.
Then click the "OK" button.
I-7530A RS-232/485/422 to CAN Converter User's Manual (Version 1.2, Sep/2011) ------------- 14