How To Configure The Module Parameters - ICP DAS USA I-7565 User Manual

4.1

How to configure the module parameters

The following procedure will guide you how to configure the
communication parameters for the CAN and USB interface. The
configuration steps are depicted as below:
1. Set the Init/Normal switch to the Init position, which is located at the
back of the I-7565 module.
2. Connect the USB cable into the I-7565 module.
3. The I-7565 module's RUN LED will flash approximately once per
second. That means the I-7565 module is working in the configuration
mode.
4. The user must run the I-7565's Utility software after they have made a
wire connection between the PC and the I-7565 via the USB port.
5. Click the "Connect" icon on the I-7565 Utility tool bar. The setting frame
will be popped up. Select which virtual COM port will be used to
connect to the I-7565 USB port, as shown in the following figure. Then
click the "OK" button.
6. Then the I-7565 configuration window will be brought out. The I-7565
Utility will show the communication information from the I-7565 module
in the window, as shown in the following figure.
I-7565 USB/CAN Converter User's Manual (Version 1.0, March/2007)
Figure 12: virtual COM port setting
------------- 20