SOLTEK SL-65MIE User Manual page 67

Onboard/CNR LAN
Selection
IDE HDD Block Mode Block mode is also called block transfer, multiple
Power ON Function This option allows you to select <KB Power ON
KB Power ON Pass-
word
Hot-Key Power ON Boot up the system via predetermined keyboard hot
Onboard FDC
Controller
Onboard Serial
Port 1 / Port2
UART Mode Select This item allows you to select UART mode.
UR2 Duplex Mode This item allows you to select the IR half/full duplex
Use the default setting.
The choice: Auto; Onboard
commands, or multiple sector read/write. If your IDE
hard drive supports block mode (most new drives do),
select Enabled for automatic detection of the optimal
number of block read/write per sector the drive can
support.
The choices: Enabled; Disabled.
Password> , <Hot-Key Power ON> or others.
The choice:Any Key; Button only; Keyboard 98;
Password; Hot-Key; Mouse Move; Mouse Click.
When user sets a password for keyboard, the pass-
word user set that return the system to Full On state.
key.
The choice: <Ctrl>+<F1>...<F12>
Select Enabled if your system has a floppy drive con-
troller (FDC) installing in the system board and you
want to use it. If you install add-in FDC or the system
has no floppy drive, select Disabled in this field.
The choices: Enabled; Disabled.
Select an address and corresponding interrupt for the
first and second serial ports.
The choices: 3F8/IRQ4; 2E8/IRQ3; 3E8/IRQ4;
2F8/IRQ3; Disabled; Auto.
The choice: Normal; IrDA; ASKIR; SCR.
function.
The choice: Full; Half.
67
Chapter 4 BIOS Setup