Binary Value Object - ABB FBIP-21 BACnet/IP User Manual

Binary value object

￭
Object Default object name
ID
BV0 RUN-STOP-Monitor
BV1 Direction-Monitor
BV2 OK-FAULT-Monitor
BV3 EXT1-EXT2-Monitor
BV4 HAND-AUTO-Monitor
BV5 Warning-Monitor
BV7 Ready-Monitor
BV8 At-Setpoint-Monitor
BV9 Enabled-Monitor
BV10 RUN-STOP-Command
BV11 Direction-Command
BV12 Run- Permissive-Com-
mand
BV13 EXT1-EXT2-Command
BV14 Fault-Reset-Command
BV17 Lock-Parameters
BV18 Control- Override-
Command
Description
Run status of drive
Rotational direction of
the motor
Actual fault status of
drive
Actual control source
Actual operating
mode
Actual warning status
Actual ready status
Actual at setpoint
status
Actual run enabled
status
Command to start
drive
Command to rotation-
al direction
Command to Run Per-
missive command
Command to External
1 or External 2
Command to fault re-
set
Actual status of para-
meter lock.
Command the drive
into BACnet Control
Override. In this mode
BACnet acquires drive
control from its nor-
mal source.
Note: The HAND mode
of the panel has prior-
ity over BACnet Con-
trol Override.
Communication protocol 45
Default active/ Inact-
ive text
RUN / STOP
REVERSE / FORWARD
FAULT / OK
EXT2 / EXT1
HAND / AUTO
WARNING / OK
READY / NOT- READY
YES / NO
ENABLE / DISABLE
RUN / STOP
REVERSE / FORWARD
ENABLE / DISABLE
EXT2 / EXT1
RESET / NO
LOCK / UNLOCK
ON / OFF
Present value access
type
R
R
R
R
R
R
R
R
R
C
C
C
C
W
R
C