ABB FBIP-21 BACnet/IP User Manual page 27

No. Name/Value Description
22 Service configur- Disable services that are not required. Each service is represented
ation by a single bit. Bit 0, Lock configuration, can be used to prevent acci-
dental changing of this parameter. By default, all services are enabled
and configuration is unlocked.
Bit
0
1
2
3
4
5
23 Reserved
...
26
27 FBA Par refresh Validates any changed adapter module configuration parameter
settings. After refreshing, the value reverts automatically to Done.
This parameter cannot be changed while the drive is running.
0 = Done Refreshing done
1 = Configure Refreshing
28 FBA Par table Displays the parameter table revision of the fieldbus adapter module
ver mapping file stored in the memory of the drive.
In format xyz, where
x = major revision number
y = minor revision number
z = correction number
This parameter is read-only.
0..0xFFFF Parameter table revision
29 FBA Drive type Displays the drive type code of the fieldbus adapter module mapping
code file stored in the memory of the drive.
This parameter is read-only.
Name Information
Lock configura- Changing this bit to one will lock service
tion configuration and no bit can be changed.
Only resetting the fieldbus configuration
will unlock the parameter. To reset the
fieldbus configuration, choose "Reset all
fieldbus settings" or "Clear all" in parameter
96.06 Parameter restore.
Disable IP con- When this bit is set, access from ABB IP
fig tool Configuration tool is prevented.
Disable ETH When this bit is set, access from Ethernet
tool network tool network (eg, ABB Drive Composer tool)
is prevented.
Disable ping re- When this bit is set, response to ICMP (ping)
sponse message is prevented.
Unsecured ETH When this bit is set, access from Ethernet
tool network tool network is unsecured.
Note: Drive Composer pro before V2.7 sup-
ports unsecured communication only.
Disable config- When this bit is set, access to web pages
uring web is disabled.
pages
Start-up 27
Default
12
0 = Done
0 hex
0