SOLTEK SL-75KIV User Manual page 69

IDE HDD Block Mode Block mode is also called block transfer, multiple
Onboard FDC
Controller
Onboard Serial
Port 1 / Port2
UART 2 Mode The second serial port on your system may offer a
IR Function Duplex This item allows you to select the IR half / full duplex
TX, RX inverting
enable
Onboard Parallel Port Select a logical LPT port name and matching address
commands, or multiple sector read/write. If your IDE
hard drive supports block mode (most new drives do),
select Enabled for automatic detection of the optimal
number of block read/write per sector the drive can
support.
The choices: Enabled; Disabled.
Select Enabled if your system has a floppy drive con-
troller (FDC) installing in the system board and you
want to use it. If you install add-in FDC or the system
has no floppy drive, select Disabled in this field.
The choices: Enabled; Disabled.
Select an address and corresponding interrupt for the
first and second serial ports.
The choices: 3F8/IRQ4; 2E8/IRQ3; 3E8/IRQ4;
2F8/IRQ3; Disabled; Auto.
variety of infrared port modes. Click here for a de-
scription of various modes. (Click your browser's Back
button, or your right mouse button, to return to this
page.)
The choices: Standard; HPSIR; ASKIR.
function.
The choices: Half; Full.
This item allows you to enable the TX, RX inverting
which depends on different H/W requirement. This
field is not recommended to change its default setting.
The choices: "No, No"; "No, Yes"; "Yes, No";
"Yes, Yes".
for the physical parallel (printer) port.
The choices: 378H/IRQ7; 278H/IRQ5; 3BC/IRQ7;
Disabled.
69
Chapter 4 BIOS Setup