Evaluation Board Hardware - Analog Devices EVAL-ADMV4640 User Manual

User Guide

EVALUATION BOARD HARDWARE

The EVAL-ADMV4640Z comes with an on-board
When evaluating the ADMV4640 device, connect the IF input to
an RF signal generator. The EVAL-ADMV4640Z runs on a 5 V dc
supply. Connect the 5 V dc supply to the VCC_5V test point, and
the ground to the GND1 test point.
analog.com
ADMV4640 chip. Figure 2
bench setup.
Figure 2. Lab Bench Setup
EVAL-ADMV4640
shows the block diagram of the EVAL-ADMV4640Z lab
Rev. A | 3 of 10