Connection of RS-485 Interface (V720-CD2D)
4-22
3. Install the connector in the Controller. Align the cable's connector with
the Controller's connector and insert the cable's connector fully into the
Controller. Tighten the retaining screws to a proper torque (about
0.3 N • m).
4.To remove the connector, completely loosen the two retaining screws
and pull the connector straight out of the Controller. If the connector is
difficult to remove, push against the Controller while pulling out the
connector.
Note Do not connect wires in the connector while it is installed in the Controller.
Retaining screws
Section 4-7