Table of Contents
Advertisement
Connection of RS-232C Interface (V720-CD1D)Connection
Connection and Disconnection of Connector
Philips screwdriver
Lock screw
4-18
· When connecting the connector, be sure to hold the connector by hand and
insert the connector. Then secure the connector with two lock screws.
· When disconnecting the connector, completely loosen the two lock screws.
Then hold the protruding part of the connector hood by hand and pull the
connector straight out. If the connector is difficult to disconnect, hold the
Controller by hand while pulling out the connector.
Note Example of Grounding from Controller
· The shielded wire must be grounded either from the Controller or the host
computer for the prevention of system malfunctions. The above is an
example of grounding from the Controller.
· Short-circuit the RS and CS pin in the connector.
Controller
Section 4-6
Host computer
Advertisement
Table of Contents
