Omron V720 Series Operation Manual page 53

Connection of RS-232C Interface (V720-CD1D)
Assembly of Connector
1, 2, 3... 1.Process the end of the cable as shown below.
• Insert the cable into the cable bushing.
• Untangle the braided shield for approximately 10 mm and fold it back
on the cable bushing.
• Apply shield tape to the untangled braided shield.
2.Solder the conductors to the plug pins.
Note Short-circuit pins 7 (RS) and 8 (CS) with a jumper.
3.Attach housing A2 of the Hood to the Plug and secure the aluminum-
taped portion with the cable clamp and two screws.
4.Put on housing B2 to complete the connector assembly.
Conductors
Braided shield
Shield tape
Jumper
Plug
Pin number
Shield
5
3
2
7 (see note)
8 (see note)
Two, M26 lock screw
Housing A2
Cable clamp
Cable bushing
Cable bushing
Aluminum tape
Symbol
GR Ground
SG Signal ground
SD Send data
RD Receive data
RS Request to send
CS Clear to send
Housing B2
Section 4-6
Name
4-17