Debugging And Uart-To-Usb Communiction; On-Board Debug Probe; Cortex ™ Debug Connector (10-Pin) - Infineon XMC4700 Relax Kit V1 Series Manual

restricted - NDA required!
Evaluation Board for XMC4000 Family
XMC4700/XMC4800 Relax Kit Series-V1
2 Hardware Description
2.5

Debugging and UART-to-USB Communiction

The XMC4700/XMC4800 Relax Kit Series-V1 supports debugging via 2 different channels:
•

On-board debug probe

™
• 10-pin Cortex Debug Connector (not assembled)
2.5.1 On-board Debug Probe
The on-board debug probe supports Serial Wire Debug (SWD) and UART communication. Both require the
installation of Segger's J-Link Driver which is part of the DAVE
development platform for the XMC
can be downloaded at www.infineon.com/dave. The latest Segger J-Link Driver can be downloaded at
www.segger.com/jlink-software.html.
debugging and UART communication.
Table 5 XMC4700/XMC4800 Pins Mapping for Debugging and UART-Communication
Pin Funtion
Data pin for Debugging via SWD
Clock pin for Debugging ia SWD
Transmit pin for UART communication (PC_RX)
Receive pin for UART communication (PC_TX)
2.5.2 Cortex
™
The 10-pin Cortex Debug Connector supports Serial Wire Debug (SWD) and Serial Wire Viewer (SWV). The pin
assignment of the Cortex
Table 6 Pin Assignment of the Cortex
Pin No. Signal Name
1 VCC
2 TMS
3 GND
4 TCK
5 GND
6 SWV
7 Key
8 NC
9 GND_Detect
10 RESET
Board User Manual
™
microcontroller families to simplify and shorten SW development. It
Table 5 shows the pin assignment of the XMC4700/XMC4800 used for
™
Debug Connector (10-pin)
™
Debug Connector is shown in
™
installation. DAVE
Input/Output
I/O
O
O
I
Table 6.
™
Debug Connector (X102)
Description
+3.3 V
Serial Wire Data I/O
Ground
Serial Wire Clock
Ground
Serial Wire Viewer (Trace Data Out)
Key
Not connected
Ground detected
Rest (active low)
12
™
is a highly efficient
http://
™
XMC Pin
TMS
TCK
P1.5 (U0C0.DOUT)
P1.4 (U0C0.DX0B)
2022-06-20
Rev. 1.4