YASKAWA SLIO Manual page 14

Basics and mounting
System conception > Accessories
Bus cover
Coding pins
14
With each head module, to protect the backplane bus connectors, there is a mounted bus
cover in the scope of delivery. You have to remove the bus cover of the head module
before mounting a System SLIO module. For the protection of the backplane bus con-
nector you always have to mount the bus cover at the last module of your system again.
The bus cover has the order no. 000-0AA00.
Please note that a coding pin cannot be installed on a 16x periphery
module! Here you have to make sure that the associated terminal block is
plugged again when the electronics unit is replaced.
There is the possibility to fix the assignment of electronic and terminal module. Here
coding pins (order number 000-0AC00) can be used. The coding pin consists of a coding
jack and a coding plug. By combining electronic and terminal module with coding pin, the
coding jack remains in the electronic module and the coding plug in the terminal module.
This ensures that after replacing the electronic module just another electronic module can
be plugged with the same encoding.
System SLIO
HB300 | IM | 053-1EC01 | en | 22-30