Standard Nose Assembly Selection; Fitting Instructions - Stanley 73200 Instruction And Service Manual

E N G L I S H

4.2 STANDARD NOSE ASSEMBLY SELECTION

The fasteners below can also be placed on the 73200 tool. It is essential that the correct nose assembly is fitted prior to
operating the tool.
FASTENER
NAME
AVBOLT® 3/16" (4.8mm)
1/4" (6.4mm)
AVSEAL® II 11mm Standard
12mm Standard
13mm Low Pressure For Nose Tip selection refer to 07900-00840 datasheet
14mm Low Pressure For Nose Tip selection refer to 07900-00840 datasheet
16mm Low Pressure For Nose Tip selection refer to 07900-00840 datasheet
INTERLOK® 3/8" (10mm)
MAXLOK® 1/4" (6.4mm)
3/16" (4.8mm)
MONOBOLT® 3/8" (10mm)
∆ Air inlet pressure of 7.0 bar required.
† Two tool actuations are needed to place these fasteners.
* It is necessary to use adaptor kit (part number 73200-04300) to fit these nose assemblies to the tool.

4.3 FITTING INSTRUCTIONS

CAUTION: The air supply must be disconnected when fitting or removing nose assemblies unless specifically
instructed otherwise.
Nose assemblies must be pre-assembled before fitting.
STRAIGHT HORIZONTAL, VERTICAL OR ROUND NOSE ASSEMBLIES
• Lightly coat the jaws with Moly Lithium grease.
Assemble Spring Guides 4 and Spring 5
•
Balance the three Chuck Jaws 3 on the upper Spring guide 4
•
(using a spent pintail to aid positioning if necessary)
• Carefully lower Chuck Collect 2 over the assembled components
• Insert Spacer 6 (if required) into Chuck Collet 2 (5/16" dia only)
• Assembly can then be located in anvil
Item numbers in bold refer to the drawing opposite.
12
STANDARD NOSE ASSEMBLY SELECTION
Ø
Refer to 07900-00905 datasheet
Refer to 07900-00905 datasheet
For Nose Tip selection refer to 07900-00840 datasheet
For Nose Tip selection refer to 07900-00840 datasheet
Standard straight equipment
Standard straight equipment
Standard straight equipment
Standard Nose Tip
O R I G I N A L I N S T R U C T I O N
NOSE EQUIPMENT
DESCRIPTION PART NO.
07220-08100
07220-07500
07220-06600
07220-06700
07220-06600
07220-06700
07220-06800 ∆
73200-04500 †
*07610-02100
*07610-02000
07220-07200 †
Fig. 4