Stanley 73200 Instruction And Service Manual page 20

E N G L I S H
BODY ASSEMBLY
Fit Head Vice Jaw* to Head 63 and use soft jaws to hold the Head Vice Jaw in the inverted orientation.
•
• Fit Body 65 on to Head 63.
Apply Loctite® 243* to thread of Handle Retaining Nut 34 and wind on to Handle 63 using Handle Retaining Nut
•
Wrench* to tighten.
Apply Loctite® 243* to thread of Air Piston Rod 58 and wind Air Piston Connector 41 on to Air Piston Rod. Tighten using
•
4mm A/F Allen key in Air Piston Rod and 14mm A/F spanner on Air Piston Connector.
• Fit Quad Seal 9 and Force Reduction Seal 35 to Air Piston 33.
Insert Air Piston 33 into Body 65 until it fits on to Air Piston Connector 41.
•
• Apply Loctite® 243* to thread of Air Piston Connector 41. Tighten Nut 3 using 27mm A/F Spanner with 14mm A/F
spanner or 5mm A/F Allen key on Air Piston Connector to prevent rotation.
• Fit 'O' Ring 8 on to Base Plate 32.
Insert Base Plate 32 into Body 65 and install Retaining Ring 24.
•
• Thoroughly clean Silencer 37 or renew if worn. Fit Silencer to Base Cap 31 and install Retaining Ring 25.
Place Gasket 36 on to Base Cap 31 and fit on to Body 65.
•
Screw Locknut 38 on to Base Plate 32 using Locknut Socket* to a minimum torque of 60Nm. If necessary, use a 10mm
•
A/F Allen key to prevent rotation of Base Plate. Outer face of Locknut 38 must be flush with or below the surface of the
Base Plate 32 threaded spigot.
OPERATING VALVE
Fit 2 'O' Rings 10 into Valve Body 42 and 2 'O' Rings 11 on to Valve Body.
•
Insert Valve Body 42 into Body 65.
•
• Fit 2 'O' Rings 11 on to Valve Spool 39.
Insert Valve Spool 39 into Body 65.
•
Fit 'O' Ring 7 to Valve Retainer 40.
•
• Apply Loctite® 243* to thread of Valve Retainer 40 and use 6mm A/F Allen key to install Valve Retainer into Body 65.
Fit 2 'O' Rings 4 on to Swivel Bolt 44.
•
• Fit Swivel 43 on to Swivel Bolt 44.
Apply PTFE Tape to thread of Swivel Bolt 44 and using 22mm A/F spanner or socket, wind Swivel Bolt into Body 65.
•
Fit Adaptor 48, Adaptor Ring 50, Retaining Nut 49 and Deflector 47.
•
* Refers to items included in 73200 Service Kit. For complete list see page 17.
Item numbers in bold refer to the General Assembly drawing and parts list (pages 21 – 22).
20
O R I G I N A L I N S T R U C T I O N