Dräger Infinity Central Station Quick Reference Manual page 25

Table of Contents

INFINITY CENTRAL STATION & M300 QUICK REFERENCE GUIDE

Select the Device setup tab.

Select the Status tab.

An arrow over the picture of the battery indicates the M300 is

on the bedside charger.

Bars inside battery indicate strength.

Signal strength is displayed in the bar graph.

For ECG Electrode status, green indicates the electrode is con-

nected to the patient, red indicates the electrode is not con-

nected to the patient.

ICS MAIN SCREEN BATTERY CHARGING CHECK

The following icons appear in the header bar of the Viewport above

the parameter box & in the header bar of the Bedview next to the pa-

tient category:

M300 on bedside

The bars inside the battery indicate the remaining charge of the M300

battery:

TO RELEARN FOR A M300 or BEDSIDE MONITORED PATIENT

Open the BedView page by selecting the viewport of the pa-

tient on the ICS Main screen.

Select the ECG relearn button on the Bedview menu bar.

For bedside monitored patients you may also select Resp re-

learn to relearn respirations.

Note: It is recommended to INITIATE A MANUAL RELEARN when:

Leads are reconnected or electrodes are repositioned

Eight hours have passed since the last learning phase

The bedside monitor displays a message indicating that it

cannot learn.

THIS GUIDE IS INTENDED FOR REFERENCE ONLY. REFER TO INSTRUCTIONS FOR USE MANUAL.ADDITIONAL INFORMATION

M300 NOT on bedside charger:

charger:

| 25

Table of Contents