Dräger Infinity Central Station Quick Reference Manual page 21

Table of Contents

INFINITY CENTRAL STATION & M300 QUICK REFERENCE GUIDE

TO SELECT A DIFFERENT WAVEFORM FOR VIEWING ON THE ICS

(BEDSIDE MONITORS ONLY)

Right-click with the mouse inside the waveform area of the

patient while on the Mainscreen.

Select Auto to maintain the display order selected at the bed-

side.

Select Manual to assign up to four waveforms to the waveform

areas. Select the arrow and choose the desired waveform or-

der.

Select the Apply button to confirm the new waveform selec-

tion. The following symbol appears in the header bar of the

Viewport in Manual mode:

TO CHANGE THE COLOR OF THE M300 PATIENT WAVEFORMS &

PARAMETER VALUES AT THE ICS

Open the BedView page by selecting the viewport of the te-

lemetry patient on the ICS Main screen.

Select Telemetry/Parameters button on the Bedview menu

bar.

Select the Layout/Parameters tab.

Select the ECG tab.

Use the arrow to select the desired color. Select Apply.

Select SpO

tab.

Use the arrow to select the desired color. Select Apply.

Note: For a bedside monitored patient, this must be completed at

the bedside monitor.

TO INITIATE A MANUAL RECORDING (R50N, if available)

Left-click the mouse in the waveform area of the patient's

Main screen viewport to display the Record button symbol

(appears for 5 seconds):

THIS GUIDE IS INTENDED FOR REFERENCE ONLY. REFER TO INSTRUCTIONS FOR USE MANUAL.ADDITIONAL INFORMATION

| 21

Table of Contents