Continuous Operation; Extended Time Mode - Fisher Scientific accuSpin 3 Operating Instructions Manual

Operation
3 If you keep the selected key pressed, the dis-
play changes at first slowly and after a few
seconds at an accelerated pace.
4 Release the key as soon as you have reached
the desired value, and adjust if necessary by
repeatedly pressing the key.
The minute display flashes for a number of
seconds, then changes to permanent display.
The run time is now stored.
You may shift the flashing cursor to set the value as
described under "Selecting speed".

Continuous operation

To switch the accuSpin™ to the continuous mode, you
must press the key until the display reads "hLd") .
38
With this setting, the centri-
fuge keeps run until stopped
manually.

Extended time mode

You can optionally switch to the extended time mode.
To switch it on or off press the program selection key
and start the centrifuge simultaneously. As far as
you keep the key pressed, the selective mode is active.
Pressing the upward key
forth between the signal menu „beep" and the time
menu "t-set".
After selecting the time menu "t-set", you can switch
between the standards time mode "00.0" and the ex-
tended time mode „00".h by pressing the upward
key .
The time input in excess of 10 hours is set in one hour
increments.
, you can switch back and